![]() Fixed potential generation failure for Adaptive Clearing.Fixed wrong toolpath issue for Turning Grooving.Fixed wrong ordering issue for 2D Contour.Fixed potential issue where Turning Profile could ignore an area of the given part.Improved rest machining quality for Turning Profile/Grooving.Fixed issue where the same cutting pass could be repeated when using rest machining for turning.Fixed wrong toolpath issue when using negative radial stock to leave for turning.(#9580)įixed fragmentation of circular cutting passes and missing potential missing cut passes for turning when using rest- machining. Fixed bad ordering issue when using both ways for Adaptive Clearing.Fixed issue where simulation shows additional stock when "No Additional Stock" is selected in the setup (#9385)įixed issue in Turning Grooving where the reduced feedrate was using feed/min instead of feed/rev mode (same as cutting- feedrate mode) (#9337).Fixed issue where rest machining does not calculate when preceded by a manual NC operation in turning operations (#9499).Fixed crash when creating 2 Manual NC commands (#9494).Fixed issue where tool is not always taken to limit when rewind is required (#9559).Changed guided deep drilling to use retract feedrate (#9310).Fixed wrong multi-axis handling for feed optimization.Fixed out of memory error when using nested patterns with the Excel Setup Sheet (#3115). ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |